YRT50|YRT Rotary Table Bearing|40*126*30mm

YRT50 High Precision Rotary Table Bearing 50*126*30mm  

CNC machine tool rotary table bearings

YRT50 bearing consist of a thrust/radial housing washer, a thrust/radial shaft washer, a thrust washer, two Axial needle roller and cage assemblies and a group of radial cylindrical roller . Housing washer and shaft washer have equally spaced fitting bolt. This kind of bearings   YRT50    have high axial load and radial load ,and high tilting rigidity and high precision.   YRT50 can be used to the machine tool and other high precision machinery of the rotary table or sub-set, and also can be used for chuck, measuring instruments and test equipment and rotary table configuration. 

High precision YRT rotary table bearings, YRT series ,YRTS series ,YRTM series, ZKLDF series.

YRT50,YRT80YRT100,YRT120,YRT150,YRT180,YRT200,YRT260,YRT325,YRT460, YRT rotary table YRT series : 

YRT580,YRT650, YRT850 ,YRT950,YRT1030

YRTM series:

YRTM50,YRTM80,YRTM100,YRTM120,YRTM150,YRTM180,YRTM200,YRTM260,YRTM325,YRTM460,YRTM580,YRTM650,YRTM850,YRTM950,YRTM1030

Leading Products 
high precision YRT rotary table bearings, YRT series ,YRTS series ,YRTM series, ZKLDF series.The precision rate has reached P5/P4/P2,ranging from 50mm --- 1300mm

Design & Installation  for   YRT50 :

Structure with the requirements shown in Figure 1

Retaining screws secure the bearing components during transport. For installing the bearing easier, the screws should be loosened before fitting, and secured again or replaced by positioning screws after fitting.

The L-section ring can be fitted with unsupported or supported ring.

a)  Without supported ring, the bearing type is   YRT50  .

b)  With supported ring, the bearing type is    YRT50 -VSP.And the whole surface of L-section should be supported.

Mounting forces must only be applied to the  YRT50  bearing ring to be fitted, never through the rolling elements.

Tighten the fixing screws in crosswise using a torque wrench (shown in figure 2).

Don’t separate or interchanged bearing components during fitting and dismantling. 

Starting friction torque can be 3 to 3.5 times as high as the value of friction torque in the dimension tables.