- Hello Customer - Log in or Register!
KOYO bearings to replace it with a new one when the vibration motor, reflected the effect is different, and must be used bearing the same as the original model, and better effect in this regard, so as to be able in this regard reflect better results. From first to introduce KOYO bearing installation.
Vibration motor bearings replaced with new ones, you must use the same bearing as the original model.
1) bearing kerosene washed, pressed into the bearing housing, to fill Shell III lithium grease to the roller bearing outer ring to two-thirds full, spread evenly with clean hands, and put on bearing gland, plus coated bolts locking plastic fastening bolts pressing the bearing gland;
2) separable bearings for the inner and outer cylindrical roller bearings, in KOYO bearings should suit the shaft and place;
3) the bearing housing mounted on the chassis, if any grease filling hole must be aligned position. Canadian coated bolt fastening bolt locking plastic pressing the bearing seat;
4) inside and outside the eccentric mounted on the shaft and in place the shaft key axis should be the key into the keyway and then loaded the outer eccentric shaft Collar installed on the shaft;
5) fasten the eccentric fastening bolt, turn the adjustable eccentric block to reach the angular position and tighten the fastening bolts to remove the front. After completion of the above assembly, the shaft should be certain axial string action;
6) on both ends of the vibration motor protective cover, fastened with screws.
KOYO bearings for installation in the form of the vibration motor and other aspects of the performance of the effect of certain changes, and also have the effect of certain changes in the form considered from a different perspective, for all aspects of installation has also been a certain understanding.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 4T-32306 NTN | 30 | 72 | 27 |
| 4T-30306D NTN | 30 | 72 | 19 |