Date: 2013-08-20

Timken motor bearings overheating Cause and Treatment Method

Timken bearings damage. Should be replaced.
2 bearing grease is too small, too much iron and other impurities. The capacity of the bearing grease should not exceed 70% of the total volume of impurities should be replaced.
3, the shaft and bearing with tight or too loose. Tight should be re-grinding, too loose should be to the shaft casement.
Timken bearing and end caps with tight or too loose. Too tight when processing bearing chamber, too loose in the end cap the inlaid steel sleeve.
5, both ends of the motor cover or poor bearing cap assembly. Cover or bearing cover only the mouth put into the loading level, tighten the screw.
6, the belt too tight or poor coupling assembly. Adjust the belt tension correction coupling.
Timken bearing lubricant too few impurities or oil ring stuck. Come on, get a new oil, repair or replace the oil ring.

Previous: TIMKEN bearings limit axial load carrying capacity
Next: INA bearings repair problems

Hot Products:

Product Model	Inside Diameter	Outside Diameter	Thickness
7000C NSK	10	26	8
7000A NSK	10	26	8

【TradeBearings News Statement】

1.The news above mentioned with detailed source are from internet.We are trying our best to assure they are accurate ,timely and safe so as to let bearing users and sellers read more related info.However, it doesn't mean we agree with any point of view referred in above contents and we are not responsible for the authenticity. If you want to publish the news,please note the source and you will be legally responsible for the news published.
2.All news edited and translated by us are specially noted the source"TradeBearings".
3.For investors,please be cautious for all news.We don't bear any damage brought by late and inaccurate news.
4.If the news we published involves copyright of yours,just let us know.