- Hello Customer - Log in or Register!
Majority of TIMKEN bearings damaged for many reasons, like beyond the original estimate of the load, non-effective sealing, tight joint caused by a small bearing clearance. Any one of the factors of these factors have their extraordinary damage type and will leave a remarkable damage a thing of the past. Therefore, the view of damage to the axis of the bearing, can invent an approximate guide due to most of the cases.
Rough on third TIMKEN bearing damage caused in the fatigue damage, the other the third due to poor lubrication, one-third of conduction due to contaminants entering the bearing or installation were not handled properly . However, these damage types also do with possessions. Analogy, pulp and paper fortune majority of half is due to poor lubrication or contamination caused by bearing damage and not due to material fatigue caused by
TIMKEN bearing the ultimate axial bearing capacity:
1, TIMKEN bearings, such as in the pure axial load, the axial load should not generally exceed 0.5 degrees of value.
2, bearing a small (diameter about 12 mm or less) and light series bearings (diameter series 8,9,0 and 1) should not bear the axial load greater than 0,25 degrees.
3, the axial load is too large, will greatly shorten the life of the bearings.
4, TIMKEN bearings to withstand a certain amount of radial load, but also to withstand the limit axial load? Generally speaking, if bearings can bear radial load, and can withstand a certain amount of axial load.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 6014 NSK | 70 | 110 | 20 |
| 16014 NSK | 70 | 110 | 13 |