Date: 2013-08-20

TIMKEN bearing installation and maintenance methods

TIMKEN bearings normally used in low speed under overload conditions, maintenance and charging or running parts of the lubricating oil difficulties.
How to reasonably TIMKEN bearing installation and maintenance of it, usually to pay attention to what elements? Bearing in the maintenance process must focus on cleaning, lubrication and so on a series of questions.
TIMKEN bearings in the production of industrial machinery is the more common type of bearing, bearing installation, maintenance, attention to the elements are as follows:
1 install, TIMKEN bearing to ensure trunnion bearing hole rotational flexibility, accuracy and smooth. Due to the TIMKEN bearing maintenance is too much trouble, so at the time of installation to ensure bearing installation completely correct, error-free. Keep the bearing can be up and running without error.
2, attention to the smooth flow of oil, oil and oil bath connected. Scraping the tank when the Institute of ideas on both sides to be soft, to form an oil film, ideas on both sides evenly to prevent oil spills. Add a lubricant to facilitate the maintenance at a later stage. Facilitate maintenance.
3, bearing and bearing block hole to repair scratch posted solid bushing 0.05~0.1mm higher subdivision surfaces, so tightly. When overall bearing pressure to prevent skewed, with fixing screws. Bearing during the installation process if deviation will lead to seize up, caused the deformation of the shaft, destruction of machinery and equipment.
4, attention to cleanliness, scraping the debugging process where it can be found in oily parts, cleaning oiled after shave repair. Bearing installation clean before, ensure that the TIMKEN bearings clean, even extremely small impurities can cause bearing damage.
5, TIMKEN bearings should always check lubricated during use, heat, vibration issues. In case of fever, smoke, a card dead as well as abnormal vibration, noise, and so you want to check in a timely manner, there are a series of failures to parse, and then take appropriate measures based on analysis of specific situations. Try to avoid causing unnecessary damage.

Previous: TIMKEN bearing installation should pay attention to matters related to
Next: INA bearing lubricants which

Hot Products:

Product Model	Inside Diameter	Outside Diameter	Thickness
RLM5530 NSK	55	65	30
RLM475720-1 NSK	47	57	20

【TradeBearings News Statement】

1.The news above mentioned with detailed source are from internet.We are trying our best to assure they are accurate ,timely and safe so as to let bearing users and sellers read more related info.However, it doesn't mean we agree with any point of view referred in above contents and we are not responsible for the authenticity. If you want to publish the news,please note the source and you will be legally responsible for the news published.
2.All news edited and translated by us are specially noted the source"TradeBearings".
3.For investors,please be cautious for all news.We don't bear any damage brought by late and inaccurate news.
4.If the news we published involves copyright of yours,just let us know.