- Hello Customer - Log in or Register!
Assembling and dismantling TIMKEN bearing force when you need to be aware of the following points:
(1) force Heli whenever possible through the axis of the TIMKEN bearing, this requires a uniform point of application symmetrically and smoothly, through the force of the sphere, or parallel to the axis.
(2) the size of the force should be smooth and uniform, not shocks, this requires the use of oil or to impose a tool for smooth tension or pressure, would certainly have a hammer is also do not fall through the copper sleeve soft scrap metal to be buffered, strike force as mitigation. It is best to use copper or copper hammer hammer.
(3) avoid the rolling force, this required assembling and dismantling the inner ring (shaft washer), through the inner ring of force, when assembling and dismantling the outer ring) by applying pressure in the outer ring.
(4) the drag force to be sustainable to the extent, for example, when installing the TIMKEN bearings TIMKEN bearings just filled to the correct location you want to stop applying pressure to ensure the rings (washers) the face arrives in bore or axial abutment face, neither squeezed too tightly and unable to load is not in place.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| RLM506230 NSK | 50 | 62 | 30 |
| RLM506225 NSK | 50 | 62 | 25 |