- Hello Customer - Log in or Register!
1. bearings TIMKEN bearings width deviation difference between actual and nominal width width.
2. the TIMKEN bearing inner ring radial runout of inner ring of Kia in a different corner locations, and relative to the outer ring of a fixed point on the surface of inner hole of the difference between the maximum and minimum radial distance. Angular position or being in the vicinity of the above points on both sides of rolling elements with inner and outer ring raceways or inner ring flange on the rear (tapered roller bearings) in the face contact bearing parts are relative to the normal position.
3.TIMKEN bearing outer ring radial runout of Kea outer ring in a different corner location, outside diameter surface with a fixed relative to the inner ring between the difference between the maximum and minimum radial distance. In the angular position of the above points, or being in the vicinity of rolling on both sides should be in back of the inner and outer ring raceways or inner ring flange (tapered roller bearings) in the face contact bearing parts are relative to the normal position.
4.TIMKEN Raceway on bearing inner ring side face runout when Sia in a different corner locations, at a distance of axis of inner ring radial distance equal to the half of the inner ring raceway contact diameter, benchmarks face and the inner ring relative to the outer ring of a fixed difference between the maximum and minimum axis distances between the points. Internal and external Raceway should be in harmony with all the rolling contact.
5.TIMKEN beats Sea the outer ring of the bearing outer ring side face of the Raceway in a different corner locations, in outer ring axis of radial distance is equal to the Raceway contact diameter of semi-ring base end and fixed relative to the inner ring of a difference between the maximum and minimum axis distances between the points. Internal and external Raceway should be in harmony with all the rolling contact.
6. end face runout of inner hole Sd in the radial distance from the axis of the inner ring is equal to half its Raceway contact diameter, perpendicular to the plane of the ring axis ring with the baseline between end of the difference between the maximum and minimum axis distances.
7. contact angle perpendicular to the axis of the TIMKEN bearing plane (radial plane) and the Heli to the rolling bearing rings or washers transmission line (known as lines) between angle.
8. ball set (OD) within one row ball bearing (outside) diameters of cylinder.
9. roller set (outside) diameter radial contact roller bearings columns roller (outer) about the diameter of the cylinder.
10. TIMKEN bearing width of public errand of ring theory of two-face (back of the washer) distance. To qualify the radial width (thrust bearing height).
11TIMKEN. the actual width of the bearing axis of radial lines and qualified bearing rings of the width of the actual face of distance between the intersection of two tangent plane. Qualified with the inner ring and outer ring side face the bearing width.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 23252CAE4 NSK | 260 | 480 | 174 |
| 22252CAE4 NSK | 260 | 480 | 130 |