Date: 2013-08-22

Thrust ball bearings use and installation notes

Thrust ball bearings use:
Thrust ball bearings use: applies only to accommodate axial loads, speeds on the lower part, applies only to accommodate axial loads, speeds on the lower parts, such as crane hook, immediate pump, immediate centrifuge, Jack, crane hooks, immediate pump, immediate, low speed centrifuge, Jack reducer. Bearing shaft washer, housing washer, and separation of rolling elements is, speed reducer. Bearing shaft washer, housing washer and rolling elements are separated, you can dismantle.
Thrust bearing installation notes:
Thrust bearing fitted to main axial load, its wide application. Thrust bearing fitted to main axial load, its wide application. Although the thrust bearing installation is relatively simple, although the thrust bearing installation is relatively simple, but the actual repair common errors still occur, the bearing ring and the ring installation location is not correct, and the bearing ring and the ring installation location is not correct result, bearing no longer, journal wear very quickly. Compression ring on the inner ring and shaft neck tie for the transition, and journal soon wear. Tight ring within ring and axis neck for transition tie Dang axis turned Shi led tight ring, and and still pieces end surface occurred friction, dang axis turned Shi led tight ring, and and still pieces end surface occurred friction, in was axis to forcing (Fx) Shi will appeared friction moments is greater than diameter tie resistance moments, to forcing (Fx) Shi, will appeared friction moments is greater than diameter tie resistance moments, Guide (Fx) to tight ring and axis tie surface forced turned, increased axis neck wear.
Therefore, installation should pay attention to the following several points of thrust bearing.
(1) distinguish between the bearing ring and the ring (based on the inner diameter of the bearing size, Aperture phase difference between the bearing ring and the ring 0.1~0.5mm). Differential 0.1~0.5mm).
(2) still distinguish between institutions (that is, not part of the movement, mainly refers to the Assembly to distinguish organizations still).
(3) no matter what, loose ring of the bearing should always be in a stationary-side surface. No matter what the situation.  

Previous: Combined needle roller bearings and precision manufacturing
Next: Wheel bearing installation you need six methods

Hot Products:

Product Model	Inside Diameter	Outside Diameter	Thickness
4T-09067/09196 NTN	19.05	49.225	19.05
4T-09078/09195 NTN	19.05	49.225	21.539

【TradeBearings News Statement】

1.The news above mentioned with detailed source are from internet.We are trying our best to assure they are accurate ,timely and safe so as to let bearing users and sellers read more related info.However, it doesn't mean we agree with any point of view referred in above contents and we are not responsible for the authenticity. If you want to publish the news,please note the source and you will be legally responsible for the news published.
2.All news edited and translated by us are specially noted the source"TradeBearings".
3.For investors,please be cautious for all news.We don't bear any damage brought by late and inaccurate news.
4.If the news we published involves copyright of yours,just let us know.