- Hello Customer - Log in or Register!
As we all know bearings are precision parts, but SKF bearings in use dirty easily. In order to ensure the normal use of the bearing, the bearing needs to be cleaned periodically, how can the cleaning to avoid damage caused by SKF bearings, SKF bearings in the future to ensure the normal operation.
First, when we will SKF bearings removed for inspection, photography and other methods shall be used to make the appearance of records. In addition, to confirm the remaining amount of lubricant and lubricant samples, and then cleaning bearings.
SKF Bearing cleaning of rough cleaning and finishing washing, and placed in the bottom of the container used metal grid. Coarse wash, brush, etc. used in the oil or grease removal adhesive material. At this point if rotating bearings in oil, attention and other damage due to foreign objects rolling surface. Sperm washing, in the oil slowly rotating bearings should be carried out carefully. Commonly used cleaning agents for the neutral water diesel or kerosene, is sometimes necessary to use warm lye. No matter which cleaning agents, filter should always be kept clean.
According to the above mentioned points, pay attention to the cleaning method. After washing, immediately SKF bearings coated rust grease oil or rust. Basic can ensure that cleaning will not cause damage to SKF bearings, to ensure the normal operation of the bearing.
In the case of rolling bearings for precision parts, and its use should also be carefully carried out, no matter how high-performance bearings use, or improper use of the effect, you will not get the expected performance of the form, but also for bearings In use should pay attention to the case are the following.
1, using the installation should carefully not form a strong punch, and does not allow a direct hit with a hammer in the form of bearing is not allowed to pass through the rolling elements in the form of pressure, but the effect in this regard is also able to reflect this form, thus to be able to exhibit better results in this respect.
2, to maintain the bearing and the surrounding environment clean form, even to the naked eye can not see the fine dust into the bearing, will increase the bearing wear, vibration and noise. Bearings and their peripheral accessories should be kept clean, especially dust and dirt, tools and working environment must be kept clean.
3, to prevent corrosion of bearings, bearing direct hand pick, to fully wash hands sweat, and coated with high-quality mineral oil before, during the rainy season and summer with particular attention to rust. However, in some special operating conditions, the bearings can get a longer life of the conventional calculation, especially in the case of light load. These special operating condition is, when the rolling surface (track and rolling member) by a lubricant film to effectively separate and restrictions may result in contamination of surface damage. In fact, under ideal conditions, the so-called permanent bearing life is possible.
4, the use of appropriate and accurate installation tools make use of special tools, try to avoid using fabric and staple fibers and the like.
Bearings through the performance of these four ways to better view after the effect of this, according to this situation to change, then the cleaning of the bearing has a great change in ways to be able to reflect slowly out such an effect, so the industry has also been a big change form.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 7316B NSK | 80 | 170 | 39 |
| 7316A NSK | 80 | 170 | 39 |