- Hello Customer - Log in or Register!
1, demolition of FAG bearings with a cylindrical bore
Demolition of inner ring, can pressure machine pull the most simple. At this point, should pay attention to the inner ring to sustain its pullout. Need to consider the dimensions of the shaft shoulder or Groove on the research process at the shoulder in order to use receiving fixture. Large-scale demolition using hydraulic method of inner ring of the bearing. By setting the oil hole oil pressure on the axis, so easy to draw. Width of large bearings for oil injection combined with drawing fixture, the demolition job.
2, taper hole of FAG bearings demolition
Removing relatively small adapter sleeve bearings, with block support for fastening on the axis of inner ring, the nut back after several times, use the pad with a hammer demolition. Big FAG bearings, no pressure to remove year easier. In operation, the bearing prolapse may suddenly, it is best to use nuts as a block.
3, the outer ring of demolition
Removal of interference the outer ring that mixes in advance on the circumference of the shell sets the extrusion screw several outer rings with screws, and equally tighten the screw, while demolition. Blind plug the screw holes on the usual cover, separation such as tapered roller bearings FAG bearings, casing abutment set out on a few cuts, using the pad and press remove, or gently beating demolition.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 23088CAKE4 NSK | 440 | 650 | 157 |
| 23988CAKE4 NSK | 440 | 600 | 118 |