- Hello Customer - Log in or Register!
Before checks are required before cleaning the machine surfaces, and then surrounding the demolition of FAG bearings parts. Oil seal is very fragile parts, need to be carefully disassemble not excessive force, and then carefully check the oil seal and its surrounding parts, if you have rendered out when adverse symptoms, be sure to replace the bad will cause damage to the FAG bearings and oil seal strict equipment downtime.
Check lubricant, dip dots lubricant on friction between the two means, if the presence of pollutants, can feel out or coated with a thin layer of lubricant on the dorsum, and rays.
Replace lubricants, oil lubrication of FAG bearings after purging old oil, and then poured into the fresh oil and let the machine at low speed of rotation for a few minutes. Oil collects residual contaminants as much as possible, and then purging these oils, oil had better filtered before use.
FAG bearings grease lubricated Joe used to replace the grease in addition should avoid contact with cotton to the FAG bearing any of the parts, fiber because these residues may be between wedge on scroll and causing damage, especially small application of bearings required more attention.
Cover exposed FAG bearings, check the bearings, don't let the bearing environment exposed to contaminants or moisture. If the work is broken, should be oiled paper plastic or similar material of his machine. If not demolition may check the case clean no masking of bearings, to the coating with brush to wash oil solvent cleaning, use a lint free cloth wipe again compressed air dry or blow dry (be careful not to allow the bearing components starting rotation).
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 24020CE4 NSK | 100 | 150 | 50 |
| 22232CDE4 NSK | 160 | 290 | 80 |