- Hello Customer - Log in or Register!
1. friction and compatibility
Shaft diameter when direct contact with the bearing preventing adhesion of forming boundary lubrication performance. Effects of friction and compatibility of materials of friction factors are:
(1) pair materials of metallurgical constitutes ease of alloy.
(2) materials and lubricants for affinity.
(3) pair materials of friction coefficient in a lubrication-free State.
(4) the microstructure of the material.
(5) the thermal conductivity of the material.
(6) material size and properties of oxide film on the surface.
2. clamping
Rigid particles at home and abroad to clamp material allows lubricants to prevent scratching or (and) ability to abrasive wear. On metallic materials, low hardness and elastic modulus of low, clamping is good, is not necessarily non-metallic materials, such as carbon graphite, lower elastic modulus, but clamping is not good. Plain FAG bearings with hard materials, usually with a relatively soft material friction pieces generally do with softer material bearing.
3. running
Shaft diameter and bearing of the break-in process, reduced size and bearing, coaxiality error, processing error surface roughness parameter values, makes contact with uniform, thus reducing friction, wear rate of capacity.
4. friction compliance
Elasto-plastic deformation compensation of material surface of sliding friction surface of initial axial flexural behavior of Misfit and. Low elastic modulus of material compliance is good.
5. wear resistance
Vice-material's ability to resist wear. Wear under conditions, the rate of wear or wear, wear to represent the back of resistance to abrasion.
6. fatigue resistance
Resistance to fatigue failure under cyclic loading capacity. Using temperatures, bearing material strength, hardness, impact fatigue strength and structure uniformity of confrontation is very important. Break-in, good clamping materials, usually poor resistance to fatigue.
7. corrosion resistance
Material's ability to resist corrosion. Lubricants when used will be gradually oxidized in the atmosphere, acidic substances, and in most also contain extreme pressure additives in lubricating oils, they all FAG bearing materials corrosion, therefore, FAG bearings requiring corrosion resistance of materials.
8. the cavitation erosion resistance of
Solid state relative to the liquid movement, when the liquid bubble near solid surface burst, have local impact high pressure or localized high temperature will cause cavitation erosion. Material's ability to resist cavitation erosion resistance known as cavitation. In General, copper-lead alloy, Tin-base FAG bearing alloy of silicon and aluminum-zinc alloy better cavitation resistance.
9. compressive strength
Accomodate load and not crush capacity or size does not change.
10. good dimensional stability
Scroll of FAG bearings are precision mechanical parts, its accuracy is based on unit of Micron. In the long term in the custody and use of, caused by stress change due to changes in the internal organization or FAG bearing size changes, resulting in loss of accuracy of FAG bearings. Therefore, in order to guarantee the precision of FAG bearings, FAG bearings steel should have good dimensional stability.
11. good rust inhibiting properties
Scroll FAG bearing numerous production processes, production cycle is longer, semi-finished or finished parts in the Assembly will take a long time before storage, therefore, FAG bearing parts in the production process or in a production are highly susceptible to a certain degree of corrosion in saved, especially in high humidity in the air. Therefore, require FAG bearing steel has good rust inhibiting properties.
12. good technological properties
Scrolling in FAG bearings in the production process, its parts after road cold and hot process. This requires should FAG bearing steel with good technological properties, such as cold and hot forming performance, cutting, grinding and heat treatment performance, and so on, to accommodate the scroll bars FAG bearing high-volume, high efficiency, low cost and high quality production needs.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 22207CKE4 NSK | 35 | 72 | 23 |
| 21306CDKE4 NSK | 30 | 72 | 19 |