- Hello Customer - Log in or Register!
High temperature and the circumferential surface of bearing rings should have good support and force uniform, in order to reduce the distortion, and can give full play to the bearing capacity of the high temperature bearing. Rings in their mating surfaces cannot slide along tangential direction, otherwise it will damage the mating surface. Free end bearing must adapt to changes in length and shaft and the bearing seat hole, which must have the ability to adapt to the axial position within a certain range of swimming. Care must be taken to make the bearing installation and removal easy, spending is labor-saving and time-saving province.
High temperature bearing diameter: measurement will be required before shipment with bearing according to the torque required to tighten the high temperature bearing cap bolt, with diameter scale, measurement of the baseline size in the micrometer Colonel, measurement to avoid the thin area. Difference between the bearing inner diameter and corresponding shaft diameter size is fit clearance.
1, before the high temperature bearing installation, should be the first to use the appropriate measuring tool, according to the bearing drawings and mechanical requirements parameters, check the bearing seat hole and processing quality, distinguish the true from the false, such as size accuracy, shape roughness workmanship, bearing model to determine whether the application supporting the use of, if not found, please immediately determine the type of change do not pretend, serious led directly to the mechanical scrap.
2, a shaft and a bearing assembly on the surface of the hole bumps, if any, burrs, rust, or solid particles ( such as debris, sand, soil), exists, not only makes the installation difficulties bearing is not correct, such as solid particles of high temperature bearing falling abrasive, bearing high temperature bearing surface injury rotation or abrasion wear, so we must check carefully before installation, if it is found that these defects, should be revised. Such as the use of oil removing burrs for the record, the fine sand cloth touch marks, rust, and Poland, if the solid particles, dirt cleaning
3, when cleaning the mounting surface should use gasoline or benzene washing, can use a clean cloth, coated with a thin oil, so that we can clearly clean convenient hum.
4, open the temporary installation package temperature bearing, it is immersed in the gasoline and other liquid hand rotation, to ensure that the cage, rolling elements and raceways, to thoroughly clean the oil surface.
Bearing 5, cleaning, when cleaning the high temperature bearing should be first with 90° to 100 °of hot melt, let the packaging and chip off the net and tools seamlessly not dig the old oil, pour the hot a few minutes, and then with kerosene, gasoline, and then rinse clean. After cleaning, should wear gloves, bearing on the table clean cloth or paper.
6, it should pay special attention to, must not be sealed high-temperature bearing this went to clean the sealing room, should remain unchanged, absolutely can not clear.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 100BAR10H NSK | 100 | 150 | 45 |
| 100BAR10S NSK | 100 | 150 | 45 |