- Hello Customer - Log in or Register!
From corrosion, cracks, spalling, indentation, abrasion, are reflected in the measurement of bearing vibration, vibration damage to the bearings FAG bearings are very sensitive, so bearings through the use of a special measuring bearing vibration (frequency Analyzer, etc) can measure the size of the vibration, through frequency cannot be inferred from specific situations of exception. Measured due to the numerical bearing conditions of use or different sensors such as installation location and therefore require prior to analysis and comparison of measurement values of each machine are determined criteria.
Even with minor injuries such as split because FAG bearings, also is making an abnormal sound and irregular sound, using the acoustic measurement can be distinguished using acoustic logging, in the operation of bearing rolling sound and sound to check, played a preventive role in advance.
1. surface metal Raceway spalling
Bearing rolling element and the inner and outer rings are subjected to cyclical fluctuation load on Raceway surface, resulting in a cycle of change
Contact stress. When a stress cycle count reaches a certain number, scroll or face inner and outer ring raceways produces fatigue spalling. If the FAG bearing load is too large, will exacerbate this fatigue. In addition, the bearing is not being installed, axis bending, also have a Raceway spalling phenomenon. Raceway on bearing fatigue peeling can reduce the running accuracy of the shaft, enabling body to vibrate and noise.
2. bearing burn
FAG bearings burned its Raceway, the scroll has temper color on the body. Burn quality reasons is lack of lubrication, lubricants in General does not meet the requirements or deterioration, as well as the bearing Assembly too tight.
3. plastic deformation
Bearing raceways and rollers do not appear on the contact surface pits, evenly, notes bearing plastic deformation. A result of a large static bearing load or under impact loading, local stress more than material yield limit of the working surface, which
Scenario generally occurs on the low speed rotation of the bearing.
4. the housing washer crack
Cracks can be caused by bearing retainer bearing too tight, foreign or inner ring of the bearing is loose, inclusive of deformation of the bearing, install the bearing surface processing such as bad.
5. cage fracture
The reason for this is lack of lubrication, rolling crush, seat tilt, and so on.
6. glue the metal cages on a rolling
Possible cause is the rolling was stuck in a cage or lack of lubrication.
7. seat Raceway badly worn
Falling into the foreign bodies may be circles, lack of lubricating oil or lubricant brands is inappropriate.
If the uses of oil hole can directly measure the bearing outer ring temperature, is more appropriate. Under normal circumstances, the bearing temperature, generally based on the bearing outside of room temperature can be presumed. If lubricated, install appropriate, bearing temperature quick rise, abnormal high temperature occurs, in which case you must stop, take the necessary preventive measures. Usually, temperature of the bearings as the run began to rise slowly, 1-2 hours later to reach a steady state. FAG bearings normal temperature due to the heat capacity of the machine, heat dissipation, speed and load to another. If necessary, use heat detector to monitor bearing temperatures at any time, and alarm or stop automatically when the temperature exceeds the specified value prevents burning shaft accident.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 23052CAKE4 NSK | 260 | 400 | 104 |
| 23952CAKE4 NSK | 260 | 360 | 75 |