- Hello Customer - Log in or Register!
The installation process and requirements of the bearing of the joint bearing is very high. Or pay attention to the installation process. We all have to pay attention to many details.
Plain bearings to the shaft installation:
1, in the occasion of the ordinary conditions of use, as long as the spherical inner race is pressed into the shaft can be, but in a complex motion occasions and synthetic load, changes in load occurs the role other occasions, where the pressed into a stepped shaft, the wish to re-use nuts or bolts to fasten.
Further, press-fitted to the shaft, it is necessary to fully come into contact with the spherical inner side surface of the stopper securement quietly pressed into Caixing.
2, to allow the tilt angle, the installation joint bearing shaft, each of each shape is allowed to tilt angle were also vary. These allow the tilt angle of the table in various dimensions.
3, the rotational speed limit. The joint rotation of the bearing speed limits, according to the load and lubrication conditions of the different respective different grease lubrication occasions.
Bearing joints in the installation process, bearing not only to take into account these problems, but also consider the related problem of grease. So in the process of installing the bearing to be careful careful careful.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 70BTR10S NSK | 70 | 110 | 36 |
| 65BAR10H NSK | 65 | 100 | 33 |