- Hello Customer - Log in or Register!
INA bearing vibration motor replacement time, reflected the effect of different, and must be used with the original bearings of the same type, but also in this area, also have a better sense of the effect, which can reflect better results in this area. First to introduce INA bearings installation from the following circumstances.
Vibrating motor when replacing the new bearing, you must use the same as the original type of bearing.
1) bearing kerosene washed, pressed into the bearing, roller bearing outer ring shell filled with lithium grease to, third, wash% 3C% 3E hands applied evenly, fit Bearing cover, fastening bolts and locking bolts coated with glue pressed Bearing cover;
2) bearings for inside and outside sets of cylindrical roller bearings are separable, the bearing should be set on the hinge and put in place;
3) bearing installed in the chassis, such as grease oiling holes must be at the location. Fastening bolts and locking bolts coated with glue pressed housings;
4) inside and outside of eccentric mounted on hinges and place, shaft keyway in the shaft key mount keys should be loaded outside of eccentric, retaining rings for shaft mounted on the hinge;
5) tightly fixed eccentric fastening bolt, turn the adjustable eccentric so that it reaches the front of the angle position and tighten the fastening bolts. Above after Assembly is complete, the hinge should have a certain amount of axial dynamic;
6) vibration motor on at both ends of the shield, with screw fastening.
INA bearing installed for vibration motor of forms and other aspects of performance are some of the effects of changes from different point of view and also there has been some change in the form of results, slowly for the installation have a certain understanding.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 7321BDF NSK | 105 | 225 | 49 |
| 7321ADF NSK | 105 | 225 | 49 |