Date: 2013-08-20

FAG bearings operate heating maintenance factor to be taken into account by

In order to check for proper installation, run checks to. Small mechanical hand rotation, to confirm that the rotate smoothly. Check the project due to foreign body, caused by scars, indentation to seize up, because of the bad installation, mounting process arising out of the bad moments are not stable, owing to the clearance is too small, caused by installation errors, seal friction torque is too large, and so on. Without exception you can start power function.
Bearing temperature, generally according to the external temperature of the bearing seat to speculate. Uses of oil hole direct measurement of the temperature of the bearing outer ring is more accurate. FAG bearing temperature, from a running start rising, usually temperature-stable after 1-2 hours. Bad if the bearings are mounted, the temperature rises dramatically, exception occurred at high temperature. The reason such as excessive lubricant, bearing clearance is too small, poor installation, sealing device too much friction. Occasions of high speed rotation, selection of bearing structures, lubrication is also the cause of the error.
To fully meet the carrying capacity of FAG bearings, bearings inner and outer rings (or after the shaft washer of the thrust bearing washers) the entire circumference must be completely solid and uniform support, seating can be cylindrical or conical surfaces, in order to check for proper installation, run checks to. Small mechanical hand rotation, to confirm that the rotate smoothly. Check the project due to foreign body, caused by scars, indentation to seize up, because of the bad installation, mounting process arising out of the bad moments are not stable, owing to the clearance is too small, caused by installation errors, seal friction torque is too large, and so on. Without exception you can start power function.
A. noise and vibration random;
B. vibration frequency of more than 1kHz;
C. regardless of the speed change, noise main frequency is almost unchanged while the sound pressure levels increase with the speed increase;
D. when radial internal clearance increases, sharp increase in the sound pressure level;
E.FAG rigid bearing increases, lower the overall sound pressure levels, even if the speed increased, the overall sound pressure levels also increase is unlikely;
F. lubricant viscosity higher sound pressure levels lower, but for grease lubrication, its viscosity, SOAP shape size can affect the noise values of the fiber.

 

Previous: SKF bearings failure prevention matters requiring attention
Next: TIMKEN bearing installation process structure

Hot Products:

Product Model	Inside Diameter	Outside Diameter	Thickness
NUP2319ET bearing	95	200	67
NUP2318ET bearing	90	190	64

【TradeBearings News Statement】

1.The news above mentioned with detailed source are from internet.We are trying our best to assure they are accurate ,timely and safe so as to let bearing users and sellers read more related info.However, it doesn't mean we agree with any point of view referred in above contents and we are not responsible for the authenticity. If you want to publish the news,please note the source and you will be legally responsible for the news published.
2.All news edited and translated by us are specially noted the source"TradeBearings".
3.For investors,please be cautious for all news.We don't bear any damage brought by late and inaccurate news.
4.If the news we published involves copyright of yours,just let us know.