In use requires very careful attitude, that change is the use of high-performance bearings, if used incorrectly, could not achieve the expected performance results, and easy to make bearing damage. Most of the bearings are bad for many reasons – exceeded the original estimate of load, non-effective sealing, tight fit was too small as a result of bearing clearances and so on. One of these factors has its special leave special damage types and shows signs of damage.
Therefore, examine the damaged shaft bearing, in the majority of cases it may cause can be found, in General, one-third bearing damage caused fatigue damage, one-third due to poor lubrication, one-third Guide for others because of improper handling of pollutants into the bearing or install.
We are going to talk about is how to protect it, extend the life of it, who is reluctant to allow the bearing wear-resistant, durable, unless you have a nerve problem (HA HA), use the bearings should be aware of the following considerations:
You want to keep the bearings and the surrounding environment clean
I do not need to know what's going on now, even though invisible to the naked eye dust into the bearing or bearing wear, to put it plainly, knead not the slightest of sand in the eyes, is a reason!
To be careful and accurate when using the Setup installation
You not even so common sense will not, if not, then don't make a bearing, to go home to play it, the most important thing is do not allow powerful punch, does not allow direct percussion with a hammer bearing, is not broken, you have to smash the deformation, do, bear the loss yourself, haha, also pass through the rolling pressure is not allowed.
Use appropriate and accurate installation tools
Using special tools as much as possible, avoid using fabric and staple fiber or something.
Prevent bearing corrosion, do not use bubble
Bearing is fine steel do of, but also fear water, if does not letter, you placed in water in the bubble 's, Oh, with hand took take bearing Shi, to full wash to hand Shang of sweat, and coated to quality mineral oil Hou again for operation, in rainy season and summer particularly to attention rust, don't told I said rust fear what, good 's, you own try try 's, see rust will is what results!
Product Model | Inside Diameter | Outside Diameter | Thickness |
7024ATYNDBLP4 NSK | 120 | 180 | 28 |
7024A5TYNDBLP4 NSK | 120 | 180 | 28 |