- Hello Customer - Log in or Register!
The bearings should be very cautious in force, because this kind of bearing is a bearing relatively high precision, so everyone in the use of the process to be circumspect. After a long-term experiment and summary. On a few points to explain how to install?
( 1 ) as possible to force through the axis of the bearing, which requires the application point of symmetrical and stable, the spherical or parallel to the axis force.
( 2 ) the size of the force should be smooth and uniform, not a shock, which requires the use of pressure or tension or pressure can exert a stable tool, we have to use the hammer, also through the copper sleeve is a soft scrap metal does not fall into the buffer, strike force as gentle as possible. It is best to use copper or copper hammer.
( 3 ) avoid through the rolling body force, which requires the assembly and disassembly of inner ring ( shaft ) through the inner force, assembling and disassembling outer ring ) by outer force.
( 4 ) drag force due to continue until the degree, for example in the installation of bearings to stop the force applied on the bearing is installed at the correct position, ensure the ring ( washer ) face arrives on abutment surface hole or shaft, can not packed tightly, they can not be installed in place.
Bearing in the installation process, not only have the requirement of installation environment but also on the bearing force is required to install. We should pay attention to.
| Product Model | Inside Diameter | Outside Diameter | Thickness |
| 105BAR10H NSK | 105 | 160 | 49.5 |
| 105BAR10S NSK | 105 | 160 | 49.5 |